Sharp VC-A410X

Q Menu Screen
O Turn on your TV and select the video channel.
@ Press the OPERATE button to turn on the VCR, and then press the
MENU button to display the MENU screen.
© Select the item you want by pressing the A or ▼ button on the
remote control. Refer to the pages listed below for details on each
item.
The following 5 items can be set by using the On Screen Display (OSD).
MENU
MODE
CHANNEL PRESET
CLOCK
LANGUAGE
SELECT :A ▼
ENTER : SET EXIT : MENU
1: TIMER .......................... Setting a timer recording (and checking it).
(See page 26 for the setting procedure.)
2: MODE ........................... VCR operating conditions are set according to
the broadcast reception and tape playback conditions. (See page 16.)
3: CHANNEL PRESET ... Setting the channels. (See page 12.)
4: CLOCK ........................ Setting the present time. (See page 11.)
5: LANGUAGE ............... Selection of language to be used for the On Screen Display. (See page 10.)
0 Press the SET button. The screen changes to the item which you have selected.
© To cancel the MENU screen, press the MENU button.
H OSD (On Screen Display)
The tape counter and VCR mode can be shown on the screen while you are playing back a tape or
watching a broadcast on the video channel.
Display example
Operating mode
Tape speed
Simple
Recording timer
Clock display
Calendar display
►
PLAY, X2
►►
VSF, FF
◄◄
VSR, REW
■
STOP, CASSETTE IN
Ilk
F.ADV
Ilk
SLOW
II
STILL
•
REC
•II
REC PAUSE
S.PICTURE ON
I bstart 11 : 0 oam I stereo
SP STOP 11 : 30AM L R
REPEAT-
12 : 30AM |REM l:05|
0:00.00
Real time counter
■S. PICTURE (New
Sharp Super Picture)
■Programme channel
position
Audio output indicator
(Only for VC-H610X)
■Auto Repeat display
Tape remaining
(or DPSS )
I DPSS
DPSS 1 9|
I NOTE >
• If the clock is not set, the time and date will not be displayed.
How to Display Indicators
O Turn on your TV and select the video channel.
© Press the OPERATE button to turn on the VCR. Mode indicators are displayed in the AUTO display
screen.
© Each time the MODE OSD button is pressed, the screen changes as follows:
O AUTO Display — ► @ FULL Display — ► © COUNTER Display — ► 0 Display off
t ____________ : _____ I
AUTO Display
When an operation button, numeric button, or CHANNEL ©/© button is pressed, the current mode or
the number of the channel will be displayed in the upper section of the TV screen for about 3 seconds.
I NOTE >
• When you record a video signal output from this VCR on another VCR, press the MODE OSD button to select
Display Off. (If the mode indicator is displayed on the screen, it is also recorded on the tape.)
15