EasyManua.ls Logo

Sharp VL-E78E

Sharp VL-E78E
29 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Part Names
Power Zoom Widemelephoto
Shoulder strap loop [p.
control lever [p. 171
VOLume control
lever [p.
19
AUDIO/VIDEO jack
jack cover
Speaker
VCR mode
---a
-CiMERA
mode
RECord START/STOP button
(in Camera mode) [p. IS]
Record button
(in VCR mode) [p. 261
BLC/GAIN-UP button [p. 221
Shoulder strap loop [p. 151
Power switch (CAMERA/VCR
select switch) [pp. 16, 191
Hand strap [p. 151
Rewind/Reverse PLAY button Fast Forward/Forward
STOP button
BATTERY
DEW/CLOG Manual FOCUS AUTO FOCUS
Manual FOCUS
LAMP OFF
indicator
indicator
Far button
button
Near button button
BAl-iERY DEW/CLOG
-$> 0
LRed
BATTERY indicator is
flashing.
DEW/CLOG indicator
is lit.
BATTERY DEW/CLOG
0 0
LRed
BATTERY OMLOG
DEW/CLOG indicator
0
:&
'&Red
is flashing.
REC indicator is
flashing.
BAnERY DEW/CLOG
BATERY and DEW/
J&_ -‘i’
CLOG indicators are
Red"'
'LRed flashing in sync.
The battery is almost depleted. Prepare a full charged battery
pack for replacement.
l Dew has formed inside the VIEWCAM. Wait for a few hours to
allow dew to dry (see page 5).
l The VIEWCAM automatically turns off within 10 seconds after
this warning operation starts.
l Do not disconnect the power source from the VIEWCAM while
this indicator is lit.
The VIEWCAM’s heads are dirty and should be cleaned (see
page 5).
l There is less than about one minute of tape remaining.
Prepare to load a new cassette.
l There is no video cassette in the VIEWCAM.
l The red erasure prevention tab in the video cassette has been
slid to the record-protect position.
l The video cassette is defective and should be removed.
l Tape protection circuit is activated. Eject the tape from the
VIEWCAM and reload it.

Related product manuals