Sharp VL-E78E

Preparation
Charging the Battery Pack
Battery Pack Refreshing
1
2
Disconnect the DC output cable from the
AC adaptor/battery charger if it is con-
nected. Insert the AC plug into a wall outlet.
The POWER indicator will light up.
Align the “V” mark on the battery pack
with the “A” mark on the charger (a).
Next, press the other side of the battery
pack down until it clicks into place (a). The
CHARGE indicator lights up.
REFRESH button
(orange)
Jtlet
3 The CHARGE indicator will go off, when
the battery pack is charged. Slide the
battery release in the direction of arrow (0)
and remove the battery pack (a). Then,
unplug the charger’s AC plug from the wall
outlet.
Battery release
B Charge only SHARP model BT-H21 or
BT-N1 battery packs. Other types of battery packs
may burst, causing personal injury and damage.
This VIEWCAM uses a Ni-Cd (nickel-cadmium) or
Ni-MH (nickel-metal hydride) type battery which
requires “refreshing” from time to time; otherwise the
operating time of the battery pack may be shortened.
Please refresh your battery pack(s) once for every
ten rechargings.
l Refreshing should be performed near the battery’s
depletion.
How to Refresh the Battery Pack
1
2
Connect the AC adaptor/battery charger to an
AC outlet and mount the battery pack on it. (The
POWER and CHARGE indicators will light.)
Press the REFRESH button. (The
CHARGE indicator will start flashing.)
l The CHARGE indicator blinks while the battery is
being refreshed. When refreshing is completed,
charging starts automatically, and the indicator is
continuously lit.
Charging and Refresh Time
Charge Time Refresh Time
I
*approx. 1 hr.
I I
BT-N1 approx. 1 hr. 10 min. *approx. 1 hr.
* Time required to refresh a depleted battery pack.
Maximum Time for Continuous Recording and
Continuous Playback
Max. Continuous Max. Continuous
Recording Time
Playback Time
I I
BT-H21 approx. 1 hr. 40 min. approx. 2 hr. 15 min,
approx. 1 hr. 20 min.
l The use of the zoom and other functions and
outdoor recording (see page 18) increases the
power consumption, so that the actual recording
time per Battery Pack may actually be approx. 50%
less than the max. continuous recording time
listed above.
l The battery pack and charger become warm during
charging. This is not a malfunction.
l The charging time and recording time depend on
the ambient temperature and the condition of the
battery pack.
l Do not refresh a fully-charged battery pack.
-
-.