19
XG-MB55X
RESETTING THE TOTAL LAMP TIMER
● Resetting the total lamp timer
When replacing the lamp, reset the total lamp timer in the procedure below.
■ The warning lights (power indicator, lamp indicator and temperature warning indicator) on the projector indicate
problems inside the projector.
■ If a problem occurs, either the temperature warning indicator or the lamp indicator will illuminate red, and the
projector will enter standby mode. After the projector has entered standby mode, follow the procedures given
below.
Lamp
■ It is recommended that the lamp (sold separately) be replaced when the remaining lamp life becomes 5% or less,
or when you notice a significant deterioration in the picture and color quality. The lamp life (percentage) can be
checked with the on-screen display.
■ Purchase a replacement lamp of type AN-XR20LP from your place of purchase, nearest Sharp Authorized Projector
Dealer or Service Center.
To Next Page
Loading...
Need help?
General
