Basic Operation
-41
Note
Hiding the Projected
Image (Shutter function)
This function allows you to tempo-
rarily hide the projected image.
1 Press SHUTTER CLOSE.
• The projected image is hidden.
2 Pressing SHUTTER OPEN will
turn the projected image back
on.
In the following cases, hiding will be cancelled
automatically.
• When STANDBY on the projector or on the
remote control is pressed.
• When a caution or information message is
displayed.
• When the power is turned on.
Displaying and Setting
the Break Timer
This function allows you to show the re-
maining time for break during meeting.
1 Press BREAK TIMER.
2 While “ ” is displayed, press ',
", \ or | to set the break timer.
• You can set anywhere between 1 and
60 minutes (in 1 units).
• The break timer starts to count down as
soon as
''
''
',
""
""
",
\\
\\
\ or
||
||
| is pressed.
Note
• Pressing UNDO will cancel the break timer.
• Auto Power Off function will be temporarily dis-
abled during the break timer.
When no input signal is detected for more than
15 minutes, the projector will automatically enter
the standby mode if the break timer has elapsed.
• The break timer will be displayed on the
startup image. To change the screen dis-
played during the break timer, change the
setting of “Startup Image” (see page 58).
• When “Slave” is set for “Stack Setting”, the
break timer is not displayed. (See page 62.)
▼On-screen display
SHUTTER
button
Mouse/adjustment
button
(
'
/
"
/
\
/
|
)
UNDO button
BREAK TIMER
button
To Next Page
Loading...
Need help?
General
