XL-30H/30W
– 10 –
1 Side Panel
(Left/Right)
1. Screw .................. (A1) x8 10-1
2 Top Cabinet 1. Screw .................. (B1) x1 10-1
Switch PWB 2. Socket ................. (B2) x2
3 Rear Panel 1. Screw .................. (C1) x1 10-1
2. Screw .................. (C2) x1
(XL-30W ONLY)
4 Main PWB/ 1. Screw .................. (D1) x3 10-2
Headphones PWB 2. Screw .................. (D2) x2
3. Bracket ................ (D3) x1
4. Socket ................. (D4) x3
5. Flat wire............... (D5) x1
6. Socket ................. (D6) x1
5 Jog Switch PWB 1. Socket ................. (E1) x1 10-2
2. Screw .................. (E2) x2
3. Knob .................... (E3) x1
6 Display PWB/ 1. Screw .................. (F1) x2 10-2
LED PWB 2. Screw .................. (F2) x3
(With Jog Motor 3. Bracket ................ (F3) x1
Holder) 4. Socket ................. (F4) x1
5. Hook .................... (F5) x2
6. Hook .................... (F6) x2
7 Front Panel 1. Screw .................. (G1) x1 10-2
2. Socket ................. (G2) x1
3. Screw .................. (G3) x1
8 Power PWB 1. Screw .................. (H1) x4 10-2
2. Screw .................. (H2) x1
3. Screw .................. (H3) x1
4. Bracket ................ (H4) x1
9 Tape Mechanism 1. Open the cassette holder 10-3
2. Screw .................. (J1) x4
10 CD PWB/ 1. Screw .................. (K1) x3 10-4
Open Close Switch 2. Hook .................... (K2) x2
PWB (Note) 3. Socket ................. (K3) x3
11 CD Mechanism 1. Screw .................. (L1) x3 10-5
DISASSEMBLY
Figure 10-2
Figure 10-3
STEP REMOVAL
PROCEDURE
FIGURE
Figure 10-1
XL-30H/30W
XL-30H/30W
Caution on Disassembly
Follow the below-mentioned notes when disassembling
the unit and reassembling it, to keep it safe and ensure
excellent performance:
1. Take cassette tape and compact disc out of the unit.
2. Be sure to remove the power supply plug from the wall
outlet before starting to disassemble the unit.
3. Take off nylon bands or wire holders where they need to
be removed when disassembling the unit. After servicing
the unit, be sure to rearrange the leads where they were
before disassembling.
4. Take sufficient care on static electricity of integrated
circuits and other circuits when servicing.
Figure 10-4
Figure 10-5
To Next Page
Loading...
