XL-E75H_OM_EN.fm
E-21
2009June 1
LT (8)
HU (7)
GR (6)
RO (5)
SK (4)
CZ (3)
PL (2)
EN (1)
UA (9)
CD operation
This system can play back a standard CD, CD-R/RW in the CD
format and CD-R/RW with MP3 or WMA files, but cannot record on
them.
Some audio CD-R and CD-RW discs may not be playable due to the
state of the disc or the device that was used for recording.
The following playback functions are the same as DVD or VCD
operations.
Page
Playback . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
To locate the beginning of a chapter (track) (skip) . . . . . . . . 14
Fast forward/Fast backward (search) . . . . . . . . . . . . . . . . . . . 14
To play repeatedly (repeat play) . . . . . . . . . . . . . . . . . . . . . . . 16
To play the contents between the specified points repeatedly
(A-B repeat) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
To change the display on TV screen . . . . . . . . . . . . . . . . . . . 18
You can playback the desired tracks in a specific order.
Maximum of 20 tracks can be programmed.
To change the programmed contents:
Repeat the above procedures from step 1.
Programmed contents will be cleared when you perform the
following operations:
z Switch the input or remove the discs.
z Set to the stand-by mode.
z Press the cursor button to select “Clear” and then press ENTER
button.
Notes:
z Sequential programming does not work if the disc disables
programming or does not have track information.
z During programmed play, repeat play can be performed by
pressing the REPEAT button (see page 16).
To select and play the desired track:
To play by specifying time (time search):
Notes:
z Direct play feature is disabled on some discs.
z Some disc cannot play from the specified point.
z Time search feature is disabled on some discs.
To play in the desired order (programmed
play)
1 Whilst in the stop or playback mode,
press the MEMORY button.
2 Enter a track number with the Direct
Search buttons.
z If you enter the wrong numbers,
press or button to select the
concerned track and then reenter
the correct numbers.
3 Press button to select “Start” then press ENTER button to
start playback the programmed track(s).
DIRECT
Track 01/23
01:18
01
02
03
04
05
06
07
08
09
10
Exit Next
TV screen
01
02
03
014
022
015
04
05
06
07
08
09
10
Clear Next
Start
TV screen
To start playback from the desired point
(direct play)
Whilst in the stop or playback mode, press the Direct Search
buttons to select the track number.
To select track 14: Press “10+” and “4”.
1 During stop or playback mode, press the DIRECT button once
and “DISC GO TO” appear on TV screen.
2 Specify the time with the Direct Search buttons.
z Enter minutes and seconds.
z To specify 1 hour 23 minutes and 40 seconds, enter
“12340”.
z If you enter the wrong number, start over from step 1.
SELECT TRACK: 14/30
TV screen
To Next Page
Loading...
Need help?
General
