8
7
6
5
4
3
2
1
E-10
ENGLISH
XL-MP333H
XL-MP444H
04/5/26 XL-MP333H_MP444H_E.fm
TINSZA022SJZZ
Preparation for Use
Caution:
" Cooling fan (XL-MP444H only)
" Connecting the AC power lead
After checking all the connections have been made correctly, con-
nect the AC power lead to the AC power input socket, then plug the
AC power lead of this unit into the wall socket. If you plug in the unit
first, the unit will enter the demonstration mode.
Notes:
! Never use a power lead other than the one supplied. Otherwise, a
malfunction or an accident may occur.
! Unplug the AC power lead from the wall socket if the unit will not
be in use for a prolonged period of time.
" Demonstration mode
! Use speakers with an impedance of 6 ohms or more, as lower im-
pedance speakers can damage the unit.
! Do not mistake the right and the left chan-
nels. The right speaker is the one on the right
side when you face the unit.
! Do not let the bare speaker wires touch
each other.
! Do not allow any objects to fall into or to be
placed in the bass reflex ducts.
! Do not stand or sit on the speakers. You may
be injured.
Incorrect
Notes:
! The speakers are magnetically shielded.
Therefore, they do not affect the display even you use them near
the TV. However, some colour variation may occur, depending on
the type of TV used.
If colour variation occurs...
Turn off the TV (from the power switch).
After 15 - 30 minutes, turn the TV on again.
If the colour variation is still present...
Move the speakers further away from the TV.
! If any kind of magnet or an electromagnet is placed too close to the
TV and the system, irregular colours may appear on the TV screen.
This product is equipped with a cooling
fan inside for better heat radiation.
When you plug the unit in for the first time,
the unit will enter the demonstration
mode. You will see words scroll.
To cancel the demonstration mode:
When the unit is in the power stand-
by mode (demonstration mode),
press the X-BASS/DEMO button.
The unit will enter the low power
consumption mode.
To return to the demonstration mode:
When the unit is in the power stand-by mode, press the X-BASS/
DEMO button again.
Note:
When the power is on, the X-BASS/DEMO button can be used to se-
lect the extra bass mode.
Wall socket
(AC 230 V, 50 Hz)
To Next Page
Loading...
Need help?
General
