03/12/18 XL-S10(U)2.fm
13
XL-S10
TINSEA018SJZZ
Basic Operation
Setting the clock
This may be operated only with the remote control.
In this example, the clock is set for the 12-hour (AM 12:00) display.
To confirm the time display:
Press the CLOCK button.
The time display will appear for about 5 seconds.
Note:
The "AM 12:00" or time will flash when the AC power supply is
restored after a power failure or unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from the beginning.
To change the 12-hour or 24-hour display:
1
Press the CLOCK button and within 5 seconds, press the
MEMORY button.
2
Within 1 minute, press the PRESET ( or ) button to se-
lect 12-hour or 24-hour display and then press the MEMO-
RY button.
"AM 12:00" The 12-hour display will appear.
(AM 12:00 - PM 11:59)
"0:00" The 24-hour display will appear.
(0:00 - 23:59)
Note that this can only be set when the unit is first installed or it
has been reset. (Refer to "Clearing all the memory (reset)" on
page 28.)
3
Within 1 minute, press the PRESET ( or ) button to ad-
just the hour and then press the MEMORY button.
When the 12-hour display is selected, "AM" will change auto-
matically to "PM".
4
Within 1 minute, press the PRESET ( or ) button to ad-
just the minutes and then press the MEMORY button.
The clock starts from "0" second. (Seconds are not displayed.)
1 Clear all the programmed contents. [Refer to "Clearing all the
memory (reset)" on page 28 for details.]
2 Perform "Setting the clock" from the beginning.
3
To Next Page
Loading...
