Sharp XL-UH1H User Manual

E-1
Factory reset, clearing all memory■
Press the ON/STAND-BY button to enter the power
stand-by mode.
Press down the VOLUME + button and button
on main unit until “CLR ALL” appears.
Caution:
This operation will erase all data stored in memory including
clock, timer settings, tuner preset, and CD program.
1�
2�
Care of compact discs■
Compact discs are fairly resistant to damage, however
mistracking can occur due to an accumulation of dirt on
the disc surface. Follow the guidelines below for maximum
enjoyment from your CD collection and player.
Do not write on either side of the disc, particularly the
non-label side from which signals are read. Do not
mark this surface.
Keep your discs away from direct sunlight, heat, and
excessive moisture.
Always hold the CDs by the edges. Fingerprints, dirt,
or water on the CDs can cause noise or mistracking.
If a CD is dirty or does not play properly, clean it with
a soft, dry cloth, wiping straight out from the centre,
along the radius.
●
●
●
Maintenance
Cleaning the cabinet■
Periodically wipe the cabinet with a soft cloth and a diluted
soap solution, then with a dry cloth.
Caution:
Do not use chemicals for cleaning (petrol, paint thinner,
etc.). It may damage the cabinet.
Do not apply oil to the inside of the unit. It may cause
malfunctions.
●
●
Troubleshooting chart (continued)
USB■
Symptom Possible cause
Device cannot be
detected.
● Is there any MP3/WMA le
available?
Is the device properly
connected?
Is it an MTP device?
Does the device contain
AAC le only?
●
●
●
●
Playback does not
start.
● Is it a copyright protected
WMA le?
Is it a false MP3 le?
●
●
Wrong time display.
Wrong le name
display.
●
●
Is Variable Bitrate le
being played back?
Is the File Name written
in Chinese or Japanese
characters?
●
●
Condensation■
Sudden temperature changes, storage or operation in an
extremely humid environment may cause condensation
inside the cabinet (CD pickup, etc.) or on the transmitter
on the remote control. Condensation can cause the unit
to malfunction. If this happens, leave the power on with no
disc in the unit until normal playback is possible (about 1
hour). Wipe off any condensation on the transmitter with a
soft cloth before operating the unit.
Before transporting the unit■
Remove all CDs from the unit. Make sure there is no CD
in the disc tray. Then, set the unit to the power stand-by
mode. Carrying the unit with discs left inside can damage
the unit.
NO YES
Correct
If problem occurs■
When this product is subjected to strong external
interference (mechanical shock, excessive static electricity,
abnormal supply voltage due to lightning, etc.) or if it is
operated incorrectly, it may malfunction.
If such a problem occurs, do the following:
Set the unit to the stand-by mode and turn the
power on again.
If the unit is not restored in the previous operation,
unplug and plug in the unit again, and then turn
the power on.
Note:
If neither operation above restores the unit, clear all the
memory by resetting it.
1�
2�

Sharp XL-UH1H Specifications

General

Brand	Sharp
Model	XL-UH1H
Category	Stereo System
Language	English