Sharp XL-UH1H User Manual

E-11
Setting the clock (Remote control
only)
In this example, the clock is set for the 24-hour (00:00)
display.
Press the ON/STAND-BY button to turn to stand-
by mode.
Press and hold the CLOCK/TIMER button until
“00:00” appear.
Within 10 seconds, press the or button
to adjust the hour and then press the MEMORY
button. Press the or button once to advance
the time by 1 hour. Hold it down to advance
continuously.
Press the or button to adjust the minutes
and then press the MEMORY button. Press the
or button once to advance the time by 1 minute.
Hold it down to advance continuously.
To conrm the time display:
[When the unit is in the stand-by mode]
Press the CLOCK/TIMER button. The time display will
appear for about 10 seconds.
[When the power is on]
Press the CLOCK/TIMER button. The time display will
appear for about 4 seconds.
Note:
The “00:00” will appear when the AC power supply is
restored after a power failure or unplugging the unit. If
incorrect, readjust the clock as follows.
To readjust the clock:
Perform “Setting the clock” from step 1.
1�
2�
�
�
Timer and sleep operation (Remote
control only)
Timer playback:
The unit turns on and plays the desired source (CD, USB,
TUNER or AUDIO IN) at a preset time.
Timer playback■
Before setting timer:
Check that the clock is set to the correct time
(refer to the column on the left). If it is not set,
you cannot use the timer function.
For timer playback, load the disc to be played
back.
1�
2�
Press the ON/STAND-BY button to turn the power
on.
Press the CLOCK/TIMER button for about 2
seconds.
Within 10 seconds, press the or button
to select “ONCE” or “DAILY” and then press the
MEMORY button.
Press the or button to adjust the hours for
timer on and then press the MEMORY button.
Press the or button to adjust the minutes for
timer on and then press the MEMORY button.
Press the or button to adjust the timer off
(as in step  and 5) and then press the MEMORY
button.
To select the timer playback source (CD, TUNER,
USB or AUDIO IN), press the or button. Press
the MEMORY button.
When you select TUNER, select a station by pressing
the or button, and then press the MEMORY
button. If a station has not been programmed, “NO
P-SET” will be displayed and timer setting will be
canceled.
1�
2�
�
�
5�
�
�

Sharp XL-UH1H Specifications

General

Brand	Sharp
Model	XL-UH1H
Category	Stereo System
Language	English