Sharp ZQ-5000

ZQ-5000
ZQ-5200
4. Select “2 RECEIVE” on the receiving unit.
2. Display the “UNIT TO UNIT” menu on the receivina unit.
I
5. Select “1 SEND” on the sending unit.
(Make sure that both the sending and receiving units are set to the
same mode.)
3. Display the “UNIT TO UNIT” menu on the sending unit.
i
I
J
(Data transfer between the two units will begin.)
Notes:
l After the data is transferred, verify it with the “VERIFY” function to
make sure that it was transferred correctly.
l When the receiving unit does not have sufficient memory capacity
to hold the data bein transferred, “MEMORY FULL” will appear. If
p?
this occurs, press C*CE ,
delete any unnecessary items in the
memory of the receiving unit, and then retransfer the data.
4. Select “3 VERIFY” on the receiving unit.
3
.( l-It.{ I T TI:I
lJt4 I T :::.
5. Select “1 SEND” on the sending unit, which initiates data verifica-
tion.
1
Verifying data
The VERIFY function can be used to see if the data has been trans-
ferred correctly. The process for verifying transmission is almost iden-
tical to the sending process.
Either Organizer can be designated as the receiving unit during
verification.
* Verifying one item of data
Recall the data to be verified and select “VERIFY”.
l Verifying all the data in one operation mode
Recall the initial display for the mode to be verified (e.g., in the
SCHEDULE mode, recall the date input display) and select
“VERIFY”.
For example, to verify all the data in the TEL1 mode:
1. Recall the initial display for TEL1 on the sending unit.
Note: When the data in the receiving unit and sending unit do not
match up, an error occurs. If this occurs, re-verify the data. If
the error message still appears, retransfer the data.
Transferring data between ZQ and EL
Series Organizers
The CE-220T Data Transfer Cable is required.
When data is transferred, it will be appended to the, data in the
receiving unit.
l Transferring one item of data
Display the data you wish to transfer, and transfer it with the
“SEND” and “RECEIVE” functions.
l Transferring all the data in one operation mode
Recall the initial display in the mode you would like to transfer
(in the SCHEDULE mode recall the date input display by
pressing ml twice) and select the “SEND” and “RECEIVE”
functions.
During data transfer, secret data (coded with “X”) is also tranS-
ferred.
But, if the secret function is ON, an error will occur.
ITEL/
(“NAME ?” will appear on the display.)
-15-