18. Troubleshooting
Q
Slider lock attachment
If the Organizer malfunctions, go over the following checklist before
sending it out for repairs:
Hold the spring with a squeezer
and insert into the chassis.
If .
Nothing appears on the
after you have pressed
The display contrast is insuffi-
cient.
The display is too dark. (All the
symbols are displayed faintly.)
No beep sounds.
None of the keys function.
“MEMORY FULL” is displayed.
The alarm does not sound at
the set time even though it has
been set.
The display fades while press-
ing a key.
Then you should
.,.
Replace the batteries. (Refer to
page
10.)
Adjust the display contrast.
(Refer to page 14.)
Replace the batteries. (Refer to
page
IO.)
Adjust the display contrast.
(Refer to oaae
14.)
I”
I
Press
m/
17
to display
”
p
“.
(Refer to oaae
14.)
Press the RESET switch. (Refer
to page 17).
Delete all unnecessary data,
then inout the new data.
Even though an alarm has been
set, the alarm will not sound if
”
c1
”
is off.
Press
(
((71
do display
IV
Q
II.
Continue using the Organizer as
usual. The batteries are becom-
ing weak.
19. Note for servicing
1.
Battery
housing
unit
@
After attaching the contact to the slider, caulk the slider rib. The
contact must be slightly moved afler caulking
Caulk.
QI
Attach the slider lock spring to the slider lock and hang it on the
pawl securely.
Slider lock
Chassis
Slider lock
First hang this section on the pawl.
x:
When attaching the slider lock, position the slider at the center.
X
Do not move the slider until the battery cover is attached.
2.
Chassis
unit
0
Buzzer attachment direction
@
Short preventing spacer attachment reference
j--
Reference
Coil short preventing spacer
Hand on the
pawl.
-17-
To Next Page
Loading...
