4. Toggle the switch/push-button connected to any of the SW terminals (SW, SW1, SW2,…)
3 times within 3 seconds (this procedure puts the Device in Learn mode). The Device
must receive on/off signal 3 times, which means pressing the momentary switch 3
times, or toggling the switch on and off 3 times.
5. The blue LED will be blinking in Mode 2 during the removing process.
6. The blue LED will be blinking in Mode 1 if the Device is successfully removed from a
Z-Wave® network.
6.3 Factory reset
6.3.1. Factory reset general
After Factory reset, all custom parameters and stored values (kWh, associations, routings, etc.)
will return to their default state. HOME ID and NODE ID assigned to the Device will be deleted.
Use this reset procedure only when the gateway is missing or otherwise inoperable.
6.3.2. Factory reset with the S button
Note! Factory reset with the S button is possible anytime.
1. To enter the Setting mode, quickly press and hold the S button on the Device until the
LED turns solid blue.
2. Press the S button multiple times until the LED turns solid red.
3. Press and hold (> 2s) S button on the Device until the red LED starts blinking in Mode 3.
Releasing the S button will start the factory reset.
4. During factory reset, the LED will turn solid green for about 1s, then the blue and red
LED will start blinking in Mode 3 for approx. 2s.
5. The blue LED will be blinking in Mode 1 if the Factory reset is successful.
6.3.3. Factory reset with a switch/push-button
Note! Factory reset with a switch/push-button is only possible within the first minute after the
Device is connected to a power supply.
1. Connect the Device to a power supply.
2. Toggle the switch/push-button connected to any of the SW terminals (SW, SW1, SW2,…)
5 times within 3 seconds. The Device must receive on/off signal 5 times, which means
pressing the push-button 5 times, or toggling the switch on and off 5 times.
3. During factory reset, the LED will turn solid green for about 1s, then the blue and red
LED will start blinking in Mode 3 for approx. 2s.
4. The blue LED will be blinking in Mode 1 if the Factory reset is successful.
To Next Page
Loading...
Need help?
General
