• SW1: Input terminal for switch/push-button
• SW2: Input terminal for switch/push-button
• SW3: Input terminal for switch/push-button
• SW4: Input terminal for switch/push-button
Wires:
• GND: 5 - 24 V DC ground wire
• +: 5 - 24 V DC positive wire
Button:
• S: S button
4.1 Installation instruction
The Device can be retrofitted into a standard in-wall console, behind switches or other places
with limited space.
⚠CAUTION! Mounting/installation of the Device to the power grid has to be performed with
caution, by a qualified electrician.
⚠CAUTION! Danger of electrocution. Make sure the voltage at the wires is not higher than 24 V
DC. Use only stabilized voltage to power supply the Device.
⚠CAUTION! Do not open the Device. It does not contain any parts that can be maintained by
the user. For safety and licensing reasons, unauthorized change and/or modification of the
Device is not permitted.
⚠CAUTION! Danger of electrocution. Make sure the voltage at the wires is not higher than 24 V
DC. Use only stabilized voltage to power supply the Device.
⚠CAUTION! Use the Device only with a power grid and appliances that comply with all
applicable regulations. A short circuit in the power grid or any appliance connected to the
Device may damage it.
⚠CAUTION! Do not shorten the antenna.
⚠RECOMMENDATION: Place the antenna as far away as possible from metal elements as they
can cause signal interference.
⚠CAUTION! Connect the Device only in the way shown in these instructions. Any other method
could cause damage and/or injury.
⚠CAUTION! Do not install the Device where it can get wet.
⚠CAUTION! Do not use the Device if it has been damaged!
⚠CAUTION! Do not attempt to service or repair the Device yourself!
⚠CAUTION! Before starting the mounting/installation of the Device, check that the breakers
are turned off and there is no voltage on their terminals. This can be done with a mains voltage
tester or multimeter. When you are sure that there is no voltage, you can proceed to
connecting the wires.
⚠CAUTION! Use only DC circuit. Do not use mixed AC and DC circuits.
⚠CAUTION! Do not insert multiple wires into one terminal.
To Next Page
Loading...
Need help?
General
