Shelly Wave i4 DC - Alarm Mode; 9 Z-Wave Parameters; Parameter No. 1 - SW (SW1) Switch Type

Adding / Removing menu - while pressing S- button - Add/Remove process selected
When the menu is executing the LED will be blinking blue in Mode 3.
Factory reset menu selected
When the menu is selected the LED will be on red, for maximum of 10 seconds.
Factory reset - while pressing S - button - Factory reset process selected
When the menu is executing the LED will be blinking red in Mode 3.
8.4 Alarm Mode
NA
9. Z-Wave® Parameters
Parameter No. 1 - SW (SW1) Switch type
This parameter defines how the Device should treat the switch (which type) connected to the
SW (SW1) terminal.
Value size: 1 Byte
Default value: 2
Values & descriptions:
• 0 - momentary switch (push button),
• 1 - toggle switch (contact closed - ON / contact opened - OFF),
• 2 - toggle switch (Device changes status when switch changes status)