6. Z-Wave® Adding / Removing / Factory reset
6.1 Adding the Device to a Z-Wave® network (inclusion).
Note! In case of Security 2 (S2) adding (inclusion), a dialog will appear asking you to enter the
corresponding PIN Code (5 underlined digits) that are written on the Z-Wave® DSK label on the
side of the Device and on the Z-Wave® DSK label inserted in the packaging.
IMPORTANT: The PIN Code must not be lost.
6.1.1. SmartStart adding (inclusion)
SmartStart enabled products can be added into a Z-Wave® network by scanning the Z-Wave®
QR Code present on the Device with a gateway providing SmartStart inclusion. No further
action is required, and the SmartStart device will be added automatically within 10 minutes of
being switched on in the network vicinity.
1. With the gateway application scan the QR code on the Device label and add the Security
2 (S2) Device Specific Key (DSK) to the provisioning list in the gateway.
2. Connect the Device to a power supply.
3. Check if the blue LED is blinking in Mode 1. If so, the Device is not added to a Z-Wave®
network.
4. Adding will be initiated automatically within a few seconds after connecting the Device
to a power supply, and the Device will be added to a Z-Wave® network automatically.
5. The blue LED will be blinking in Mode 2 during the adding process.
6. The green LED will be blinking in Mode 1 if the Device is successfully added to a
Z-Wave® network.
6.1.2. Adding (inclusion) with the S button
1. Connect the Device to a power supply.
2. Check if the blue LED is blinking in Mode 1. If so, the Device is not added to a Z-Wave®
network.
3. Enable add/remove mode on the gateway.
4. To enter the Setting mode, quickly press and hold the S button on the Device until the
LED turns solid blue.
5. Quickly release and then press and hold (> 2s) the S button on the Device until the blue
LED starts blinking in Mode 3. Releasing the S button will start the Learn mode.
6. The blue LED will be blinking in Mode 2 during the adding process.
7. The green LED will be blinking in Mode 1 if the Device is successfully added to a
Z-Wave® network.
Note! In Setting mode, the Device has a timeout of 10s before entering again into Normal mode.
To Next Page
Loading...
Need help?
General
