Root device - Association Group 8
Allowed nodes: 9
It is assigned to switch connected to the SW4 terminal (uses Basic command class).
Triggered by SW4. Supports the following command classes:
• BASIC_SET : set On / Off state at the associated device
Root device - Association Group 9
Allowed nodes: 9
It is assigned to switch connected to the SW4 terminal (uses Switch Multilevel command class).
Triggered by SW4.
It is recommended to use push buttons for this association. Supports the following command
classes:
• SWITCH_MULTILEVEL_START_LEVEL_CHANGE : initiate a transition to a new level
(increase or decrease light intensity in case of dimmer, or move shutter up or down, …)
• SWITCH_MULTILEVEL_STOP_LEVEL_CHANGE : stop an ongoing transition (stop increase
or decrease light intensity in case of dimmer, or stop moving shutter up or down, …)
To Next Page
Loading...
Need help?
General
