To Next PageTo Next PageWhat to do if other Sherwood components do not react to remote control commands?
If other Sherwood components aren't reacting to remote control commands, it could be because DIGI LINK connections are not made properly. Ensure you make proper DIGI LINK connections.
Guide to safely unpacking and setting up the audio/video receiver for optimal performance.
Important safety warnings, precautions, and FCC compliance details for the receiver.
Details on voltage selection, power supply, and safety precautions for different regions.
Instructions for connecting audio sources like CD players and tape decks to the receiver.
Guide for connecting video sources like VCRs and DVD players to the receiver.
Steps for connecting FM and AM antennas for optimal radio reception.
How to properly connect front, rear, and center speakers to the receiver.
Guide for connecting digital audio sources via coaxial or optical cables.
Instructions for interconnecting Sherwood components using DIGI LINK system.
How to use pre-out jacks for external amplifiers or powered speakers.
Information on connecting the AC power cord and using switched AC outlets.
Overview of buttons, indicators, display, and input jacks on the receiver's front panel.
Explanation of remote control buttons for receiver and component operation.
Information on the remote's effective range and battery installation.
Steps to power on the receiver and select an audio or video input source.
How to adjust bass, treble, Cinema EQ, and mute the sound.
Instructions for listening privately using headphones.
Description of the 8 available surround sound modes for immersive audio.
Guidelines for optimal speaker placement and supported speaker configurations.
How to choose and activate different surround sound processing modes.
Setting speaker size, position, and subwoofer for optimal surround.
Fine-tuning the volume level for each individual speaker channel.
Using the test tone function to balance speaker volume levels accurately.
Setting delay times for speakers to synchronize sound arrival for better imaging.
Reproducing multi-channel audio through two speakers or headphones.
Guide to auto tuning, manual tuning, and presetting radio stations.
How to scan through stored radio stations sequentially.
Instructions for recording audio using the tape monitor function.
Steps for dubbing video and audio content between components.
How to dub video and audio signals from different sources onto VIDEO 1.
Viewing current settings and adjusting dynamic range compression for Dolby Digital.
Setting the sleep timer and adjusting the brightness of fluorescent displays.
On-screen display of current input source, test tone status, and volume.
Navigating setup menus for speaker mode, surround, delay time, and channel trim.
A guide to diagnosing and resolving common issues with the receiver.
Detailed technical data for amplifier, digital audio, video, tuner, and general sections.
General
