TOCV-CP_IMshort_Control-ver-2_Rev07F Page 17 of 22
(Software version ≥ 2.00) effective date: September 2007
Sample Group Wizard –4 Calibration Curve Check
- Select the control samples to be inserted with the calibration curves
Select the control sample to be attached to the calibration curve.
These parameters can be entered for each calibration curve
selected in Sample Wizard 4.
Sample Group Wizard –5 Controls
- to define the sequence of control samples
At the beginning of the
sample group
Select this item to insert a control sample before the sample
analysis
Always, after “number “ of
samples
Select this item to inert a control sample after every fixed
number of samples. Enter that number in the box
At the end of the sample
group
Select this item to insert a control sample at the end of the
sample analysis
Displays the information related to the added control samples.
Up to 3 separate control samples may be added
Use this button to add a control template
Highlight a control template listed in the window and click on
the Delete button to remove this from the sample group
Click on the [Finish] button to save changes and add the sample
group to the Sample Table.
To Next Page
Loading...
