29
Lighting pattern*1 Indication conditions Recovery Error code*2
(Repeatedly flashes red 4 times)
Communication error with the
bicycle system
Make sure that the cable is not loose or
improperly connected.
If the situation does not improve, contact
the place of purchase.
E024
This is displayed if an error
occurs during charging.
Remove the battery charger from the
battery and press the power switch. If an
error is displayed, contact the place of
purchase.
No display
(Repeatedly flashes red 3 times)
If the temperature exceeds the
guaranteed operating range,
the battery output is turned
off.
If it has exceeded the temperature in
which discharge is possible, leave the
battery in a cool place away from direct
sunlight until the internal temperature of
the battery decreases sufficiently. If it is
below the temperature in which discharge
is possible, leave the battery indoors, etc.
until its internal temperature is at a
suitable temperature.
If the situation does not improve, contact
the place of purchase.
W020
(Repeatedly flashes red 1 time)
This is displayed when a
genuine drive unit is not
connected.
This is displayed if any of the
cables are disconnected.
Connect a genuine battery and drive unit.
Check the condition of the cables.
If the situation does not impr
ove, contact
the place of purchase.
E025
*1
: Flashing
*2 Displayed on the cycle computer.
To Next Page
Loading...
