2
The user's manual can be seen at the
following link:
https://si.shimano.com
IMPORTANT NOTICE
•
Contact the place of purchase or a bicycle dealer for
information on installation and adjustment of the products
which are not found in the user's manual. The dealer's manual
for professional bicycle mechanics is available from our
website (https://si.shimano.com).
•
Do not disassemble or modify the product.
•
Please observe the appropriate rules and regulations of the
country, state or region in which you conduct your business as
a dealer.
•
Also, read the SHIMANO STEPS user's manual.
For safety, be sure to read this user’s
manual thoroughly before use, and
follow it for correct use.
GENERAL SAFETY
INFORMATION
For information on the replacement procedure,
contact the place of purchase or distributor.
Be sure to observe the following instructions in order
to avoid burns or other injury fr
om fluid leakage,
overheating, fire, or explosion.
TO ENSURE SAFETY
DANGER
Handling the battery
•
Use the specified battery charger for charging and observe the
specified charging conditions. Doing otherwise may cause
overheating, bursting, or ignition.
•
Do not leave the battery near sources of heat such as heaters.
Doing so may cause it to burst or ignite.
•
Do not heat the battery or throw it into a fire.
Doing so may cause it to burst or ignite.
•
Do not deform, modify, disassemble or apply solder directly to
the battery. Doing so may cause it to leak, overheat, burst, or
ignite.
•
Do not connect the terminals with metallic objects. Doing so
may cause them to short circuit or overheat, and result in
burns or injury.
•
Do not carry or store the battery together with metallic objects
such as necklaces or hairpins.
Doing so may cause it to short circuit or overheat, and result in
burns or injury.
•
Do not place the battery into fresh water or sea water, and do
not allow the battery terminals to get wet. Doing so may
cause overheating, bursting, or ignition.
•
Do not throw or subject the battery to strong shock. Doing so
may cause overheating, bursting, or ignition.
Handling the battery charger
•
Do not allow the battery charger to get wet. If it is wet or
water is allowed inside, it could cause a fire, ignition,
overheating, or electric shock.
•
Do not use it while it is wet, and do not touch or hold it with
wet hands. An electric shock may occur
•
Do not cover the battery charger with a cloth while it is in use.
Doing otherwise may cause the heat to build up and the case
may become deformed, or fire, ignition, or overheating may
occur.
•
Do not disassemble or modify the battery charger.
If this is not observed, electric shocks or injury may
occur.
•
Use the battery charger at the specified power supply voltage
only. If a power supply voltage other than that specified is
used, fire, explosions, smoke, overheating, electric shocks or
burns may occur.
•
Use the specified battery and charger combination
for charging and observe the specified charging
conditions.
Doing otherwise may cause overheating, bursting,
or ignition.
WARNING
•
After reading the user's manual thoroughly, keep it in a safe
place for later reference.
•
Do not insert or remove the plug while it is wet. Doing so may
result in electric shock. If there is water leaking out of the
plug, dry it thoroughly before inserting it.
•
Do not recharge the battery in wet or very humid places, or
outdoors. A fire, ignition, overheating, or electric shock may
occur.
To Next Page
Loading...
