EasyManua.ls Logo

Shimano Steps BT-E8035 - Page 6

Shimano Steps BT-E8035
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
Use the product under the supervision of someone
responsible for safety and upon receiving usage
instructions. Do not allow physically, sensory, or
mentally impaired persons, inexperienced persons,
or persons with no required knowledge, including
children, to use the product. Do not allow children
to play near the product.
NOTICE
Charging can be carried out at any time, regardless of
the remaining battery, but please fully charge the
battery in the following cases:
The battery cannot be used at the time of purchase. Before
riding, be sure to fully charge the battery.
If the battery has become completely empty, charge
it as soon as possible. If you leave the battery
without charging it, the battery will deteriorate and
may become unable to be used.
Handling the battery
If the screen of the cycle computer is not displayed, fully
charge the battery. The battery level may affect the display.
If the LED display of the battery does not turn on even when
the battery power switch is pressed, the protection circuit may
have activated. Connect the battery charger to deactivate the
protection circuit.
If the battery is charged in a low-temperature environment of
5°C or lower, the traveling distance of a full charge will be
shorter. Also, if the battery is used in a low-temperature
environment of 5°C or lower, the battery consumption will
become quicker. This is due to the characteristics of the
battery, and the battery will return to normal when at a
normal temperature.
Handling the battery charger
The battery can be charged at temperatures between 0°C and
40°C. The battery charger will not operate at temperatures
outside the range. It will display an error. (The battery charger
LED lamp flashes.)
Do not use outdoors or in environments with high humidity.
Charge the battery indoors to avoid exposure to rain or wind.
Do not place the battery charger on dusty floors when using
it.
Place the battery charger on a stable surface such as a table
when using it.
Do not place any objects on top of the battery charger or its
cable. Also, do not remove the cover.
Do not bundle the cables.
Do not hold the battery charger by the cables when carrying
it.
Do not apply excessive tension to the cable and charging plug.
In order to prevent the cable from being damaged, avoid
wrapping it around the main body during storage.
Do not wash the battery charger or wipe it using detergents.
Do not allow children to play near the product.
When charging with the battery installed to a bicycle, take
care that your legs, etc. do not get caught in the battery
charger cord. Doing so may cause injury or cause the bicycle
to fall over and break the components.
When charging the battery while it is mounted on the bicycle,
be careful of the following:
-
Before charging, check that there is no water on the
charging port of the charging plug.
-
Check that the battery mount is locked before charging.
-
Do not remove the battery from the battery mount while
charging.
-
Do not ride with the charger mounted.
-
Close the cap on the charging port when not charging.
-
Fix the bicycle in place when charging, so that it does not
tip over.
Make sure to close the charge socket cap after charging is
complete. If foreign material such as dirt or dust is attached to
the charge socket, the charging plug may become unable to
be inserted.
Using the battery outside the operating temperature range
may cause problems with operation or performance
degradation.
The charging time is longer when the battery temperature is
high.
Cleaning
The number written on the key of the battery mount is
necessary when purchasing a spare key. Store it carefully.
Do not use thinner or other solvents to clean any of the
components. Doing so may damage their surface.

Other manuals for Shimano Steps BT-E8035

Related product manuals