28
Power ON/OFF
•
The power cannot be turned ON while charging.
•
When the bicycle has been stopped for 10 minutes, the auto power OFF function automatically switches the power OFF.
NOTICE
• Check the following prior to turning the power ON.
-
The battery is firmly attached to the battery mount.
-
The cycle computer is firmly attached to the bracket (refer to the “SHIMANO STEPS cycle computer user's manual”).
• Do not step on the pedal when turning the power ON/OFF. Doing so may cause a system error.
• The built-in battery of the satellite system on/off switch / cycle computer is charged while the system is running. If the charge is insufficient because of
long-term storage, etc., charge the built-in battery using one of the methods below. It takes a maximum of two hours to charge the built-in battery.
-
Charge the (main) battery while it is mounted on the bicycle. (BM-E6000 / BM-E6010 / EW-CP100 only)
*
When the (main) battery is fully charged, charging of the built-in battery also stops automatically.
-
The power can be turned ON using the power button of the (main) battery.
*
The power automatically turns OFF if the bicycle is stopped for 10 minutes. When charging for more than 10 minutes, operate any switch on the
bicycle or turn the crank to keep the system running.
-
Charging can be carried out by connecting the satellite system on/off switch / cycle computer to the PC version of E-TUBE PROJECT. Make a request
to the place of purchase.
Turning the power ON from the cycle computer
The power button is not equipped, depending on the model of the cycle computer. Use another method to turn the power ON.
1.
Press the power switch.
The button may need to be held down, depending on the
model of the cycle computer. Hold down the button until
the screen turns on.
Power button
Turning the power ON from the satellite system on/off switch
The position of the satellite system on/off switch differs depending on the bicycle.
1.
Press and hold the power button for 0.5 seconds.
•
The LED turns on for a short period of time. If the power is
turned ON normally, the LED will light up for several
seconds.
•
The LED flashes twice when turning the power ON, if the
built-in battery capacity of the satellite system on/off switch
has decreased. The built-in battery will be charged if you
leave the power ON for a little while.
LED
Power button
To Next Page
Loading...
