32
Symptoms Causes/possibilities Remedies
The screen of the cycle
computer or the LED of the
satellite system on/off switch
turns on for a short period of
time when the satellite system
on/off switch is pressed, but
the power cannot be turned
ON.
Is the (main) battery level too low? Charge the (main) battery.
Is the (main) battery properly connected?
Check that the (main) battery is securely
connected. If the power still does not turn ON,
contact the place of purchase.
The level of the built-in battery of the satellite
system on/off switch is too low.
The built-in battery of the satellite system on/
off switch needs to be charged. Refer to
"Power ON/OFF."
Battery LED lamp error indication
System errors and equivalent warnings are displayed with various light up patterns of the battery LED lamp
When there are five battery LED lamps
Lighting
pattern*1
Indication conditions Recovery
Battery overcurrent
protection occurred.
If it occurs during charging, remove and reconnect the charging plug.
If the situation does not improve, have your place of purchase perform the
following.
•
Connect a genuine SHIMANO battery. Also check the power cord for
abnormalities. If the error persists, contact your distributor.
If the temperature
exceeds the
guaranteed operating
range, the battery
output is turned off.
If the temperature is higher than the temperature at which discharging is possible,
leave the battery in a cool location with no direct sunlight until the internal
temperature of the battery has decreased sufficiently. If the temperature is lower
than the temperature at which discharging is possible, leave the battery indoors
until the internal temperature has increased to an appropriate temperature.
Battery does not
recognize the drive
unit.
If it occurs during charging, remove and reconnect the charging plug.
If the situation does not improve, have your place of purchase perform the
following.
•
Connect a genuine SHIMANO battery. Also check the power cord for
abnormalities. If the error persists, contact your distributor.
This is displayed if an
error occurs during
charging.
Remove the battery charger from the battery and press the power switch. If an
error is displayed, contact the place of purchase.
Electrical abnormality
in battery detected.
Remove the battery charger after connecting it to the battery. Make sure to press
the power switch with the battery connected.
If an error is displayed for the battery alone, have your place of purchase perform
the following.
•
Connect a genuine SHIMANO battery. Also check the power cord for
abnormalities. If the error persists, contact your distributor.
*1
: Off : Lights up : Flashes
To Next Page
Loading...
