Shimano EP600 - Using and Exiting Walk Assist Mode

Carefully push the bicycle while pressing Y again.
The drive unit operates while Y is pressed to assist you in pushing the bicycle.
When the drive unit is operating, the LED and screen displays change as shown in the figure.
X
Y
Y
X
2-switch type 3-switch type
LED2
(Flashing blue)
Cycle computer example
Walk assist operates at a maximum of 6 km/h. Be careful because the bicycle starts moving just by
pressing Y.
During electronic gear shifting, the level of assistance of walk assist and speed are controlled by the
current gear position.
2.
Exit walk assist mode.
Press the button (X button) on the upper side of the assist switch (left side of the handle).
X
Y
Y
X
2-switch type 3-switch type
LED2
3.
Quick guide
23