Do not place the splicer in an unstable or unbalanced position. The splicer may
shift or lose balance, causing the unit to fall. Possible personal injury or
equipment damage may result.
The splicer is precision adjusted and aligned. Do not allow the unit to receive a
strong shock or impact. Possible equipment failure may result. Use supplied
carrying case for transportation and storage. The carrying case protects the
splicer from damage, moisture, vibration and shock during storage and
transportation.
Follow the below listed instructions for handling electrodes.
a) Use only specified electrodes.
b) Set the new electrodes in the correct position.
c) Replace the electrodes as a pair.
Failure to follow the above instructions may cause abnormal arc discharge. It can
result in equipment damage or degradation in splicing performance.
Do not use any chemical other than pure alcohol (99% or greater) to clean the
objective lens, V-groove, mirror, LCD monitor, etc., of the splicer. Otherwise
blurring, discoloration, damage or deterioration may result.
The splicer requires no lubrication. Oil or grease may degrade the splicing
performance and damage the splicer.
The equipment must be repaired or adjusted by a qualified technician or
engineer. Incorrect repair may cause fire or electric shock. Should any problems
arise, please contact your nearest sales agency.
To Next Page
Loading...