Do not touch the splicer, AC power cord and AC plugs with wet hands. This
may result in electric shock.
Do not operate splicer near hot objects, in hot temperature environments, in
dusty/humid atmospheres or when water-condensation is present on the splicer.
This may result in electric shock, splicer malfunction or poor splicing
performance.
When using Li-ion battery, follow the instructions below. Failure to follow these
may result in explosion or personal injury.
a) Do not charge battery with other methods than instructed.
b) Do not discard battery into an incinerator or fire.
c) Do not charge or discharge battery near a flame or under direct sunlight.
d) Do not excessively shake or jar the battery.
e) If battery leaks of liquid residue, be careful handling the battery so the
liquid does not get in skin or eye contact. If it reaches contact,
immediately wash skin or eyes thoroughly and see the doctor. Dispose
of the battery and call the service center for replacement.
f) If charge did not complete in four hours or the "CHARGE" LED is
constantly on, immediately stop charging and call the service center for
repair.
Do not store splicer in any area where temperature and humidity are extremely
high. Possible equipment failure may result.
Do not touch protection sleeve or tube-heater during heating or immediately
after completion of heating. Their surfaces are very hot and touching these may
To Next Page
Loading...