Safety glasses should always be worn during fiber preparation and splicing
operation. Fiber fragments can be extremely dangerous if it comes into contact
with the eye, skin, or is ingested.
Use only proper power source.
a) Check the AC power source before use: Proper AC power source is
AC100-240V, 50-60Hz. Proper DC power source is DC10-12V.
Improper AC or DC power source may cause fuming, electric shock or
equipment damage and may result in personal injury, death or fire;
b) AC generators commonly produce abnormally high AC output voltage
or irregular frequencies. Measure the output AC voltage with a circuit
tester before connecting the AC power cord. Such abnormally high
voltage or frequency from a generator may cause fuming, electric shock
or equipment damage and may result in personal injury, death or fire.
Make sure the generator is regularly checked and serviced.
Do not modify, abuse, heat or excessively pull on the supplied AC cord. The use
of a damaged cord may cause fuming, electric shock or equipment damage and
may result in personal injury, death or fire.
OFS-95 uses a three-prong (core) AC cord that contains an earthed ground safety
mechanism. The splicer MUST be grounded. Use only the supplied three-prong
(core) AC power cord. NEVER use a two-prong (core) power cord, extension
cable or plug.
Connect AC power cord properly to the splicer (inlet) and wall socket (outlet).
When inserting the AC plug, make sure there is no dust or dirt on the terminals.
Engage by pressing the female plug into the splicer (inlet) and the male plug into
the wall socket (outlet) until both plugs are fully seated. Incomplete engagement
may cause fuming, electric shock or equipment damage and may result in
personal injury, death or fire.
Do not short-circuit the terminals of AC adapter and optional battery. Excessive
To Next Page
Loading...