(outlet) immediately if user observes the following or if the splicer receives the
following faults:
a) Fumes, bad smell, noise, or over-heat occurs.
b) Liquid or foreign matter falls into cabinet.
c) Splicer is damaged or dropped.
If this occurs, ask our service center for repair. Leaving the splicer in a damaged
state may cause equipment failure, electric shock or fire and may result in
personal injury, death or fire.
Use only the AC adapter / battery charger designed for this splicer. Using an
improper AC power source may cause fuming, electric shock or equipment
damage and may result in personal injury, death or fire.
Do not disassemble or modify the splicer, AC adapter or battery. In particular, do
not remove or bypass any electrical or mechanical device (e.g. a fuse or safety
switch) incorporated into the design and manufacturing of this equipment.
Modification could cause damage that may result in personal injury, death,
electric shock or fire.
Never operate the splicer in an environment where flammable liquids or vapors
exist. Risk of dangerous fire or explosion could result from the splicer’s
electrical arc in such an environment.
Do not use compressed gas or canned air to clean the splicer. They may contain
flammable materials that could ignite during the electrical discharge.
Do not touch the electrodes when the splicer is on and power is supplied to the
unit. The electrodes generate high voltage and high temperatures that may cause
a severe shock or burn.
NOTE: Arc discharge stops when wind protector is opened.
Turn the splicer off and disconnect the AC power cord before replacing
electrodes.
To Next Page
Loading...