Introduction
Introduction
ShinewayTech
OFS-95 Optical Fiber Fusion Splicer is for fiber fusion with low
splice loss and ensures splice long-time stabilization. Splice loss depends on
certain conditions like fiber preparation, splicing parameters, fiber condition,
variation after splicing and etc.
The standard principle of splicing is not complicated, firstly the splicer finds the
fiber core and aligns it correctly, and then it splices the fiber with the arc
generated by the electrodes. There are two major technologies to ensure
high-quality splice, LID (Local Injection and Detection) and CDS (Core
Detection System), which is also widely known as PAS (Profile Alignment
System).
OFS-95 with PAS technology is designed for splicing many types of optical
fibers. It is small in size and light in weight, making it suitable for any operating
environment. It is easy to operate and it splices fast while maintaining low splice
loss. In order to achieve the splicer's full capabilities, read the following
important information.
➢ Splice mod
Use [SM] splice mode for standard SM fiber (ITU-TG.652) splicing. It
completes in 9 seconds and is the quickest mode for SM fiber splicing.
Use [AUTO] splice mode if fiber type is not identified. Splice takes longer but it
covers most conventional fibers splicing for following reasons.
a) [AUTO] mode first identifies fiber type by analyzing fiber profile, and then
unique splicing condition is chosen for the type of fiber. The types of fibers
covered by [AUTO] are all the conventional fibers, such as SMF (G652),
NZDSF (G655), MMF (G651), etc. The [AUTO] modes takes longer for the
above processes but is recommended in fiber type is not sure.
b) [AUTO] mode comes with automatic arc calibration function, which
observes the splicing process and feedback adequate heat power information
To Next Page
Loading...