Introduction
to the next splice (See next chapter for detail).
➢ Automatic arc calibration function
This function calibrates the arc power at every splice. When the automatic arc
calibration function is enabled, performing the [Arc calibration] function before
a splice operation is not necessary. The automatic arc calibration function works
in AUTO modes only. It doesn’t work in the standard splice modes. When using
those modes, performing [Arc calibration] before splicing is strongly
recommended.
➢ Environment Performance
To operate by the bad environment, the splicer has improved the performance.
Dropping
Water-Proof
Dust
ShinewayTech does not guarantee that the splicer will not be damaged under
these conditions.
➢ Unique function
a) Operating display can be changed
The OFS-95 can be operated with monitor in front or at back. The fiber/display
image on the monitor can be changed.
b) Sheathe clamping method
Either conventional sheathe clamping system or “fiber holder system (optional)”
can be selected.
c) Carrying Case with worktable.
The top cover of caring case can be used as a work table.
To Next Page
Loading...