Menu Operation
Select an appropriate splice mode for type of fiber to be spliced, press
or button to select splice mode, click button to confirm.
“1 AUTO SM/NZ/DS/MM” mode is recommended for splcing in most cases,
in which the splicer will automacially adjust splice parameters according to fiber
type.
C. Edit Splice Mode
Splicing parameters in each splice mode can be modified.
In [Select Splice Mode] menu, press button to enter “Edit Splice Mode”
and modify splice mode as shown above:
Press or button to select the parameter to be modified, press
button to enter parameter setting.
Press or button to modify parameter, press button to confirm.
To Next Page
Loading...