36(65)
2.5 Operation Procedures
2.5.1 Installation steps for options water manifold (dewaxing)
1) Install copper joint to the level valve.
2) Install level valve with copper joint to the dewaxing water manifold.
3) Install water manifold to the machine.
4) Install Teflon to copper joint.
Note!
For the operating temperature not higher than 200℃, Teflon with
temperature resistance 200℃ is usable; for the operating temperature
from 200 to 300℃, must use Teflon with temperature resistance 300℃.
2.5.2 Installation steps for options water manifold (welding)
To Next Page
Loading...
Need help?
General
