Shini STM-PW Series User Manual

Name: Shini STM-PW Series
Brand: Shini
Rating: 4 (1 reviews)

65 pages

To Next Page

To Previous Page

51(65)

Picture 4-11: Equipment Setting

13) Setting mold temperature (if temp. has been set, this step can be omitted).

Press SV key and control value column would be flashing, press ◄/► key to

move cursor then press ▲/▼ key to change values. Finally press SET key to

confirm them. Maximum setting temperature of STM is 160℃.

14) After setting desired value, press RUN/RESET key to begin temperature

Questions and Answers:

Need help?

Do you have a question about the Shini STM-PW Series and is the answer not in the manual?

General