Shiv S-works - Default Chapter; Table of Contents

THIS INSTRUCTION GUIDE CONTAINS IMPORTANT INFORMATION.
PLEASE READ CAREFULLY AND STORE IN A SAFE PLACE.
Please note all instructions and notices are subject to change and updates without notice.
Please visit www.specialized.com for periodic tech updates.
Feedback: techdocs@specialized.com
SPECIALIZED BICYCLE COMPONENTS
15130 Concord Circle, Morgan Hill, CA 95037 (408) 779-6229
0000051673_IG_R1, 04/2015
TABLE OF CONTENTS
INTRODUCTION ............................................................................................................................ 1
TOOLS REQUIRED ......................................................................................................................... 1
FRAME PREPARATION ................................................................................................................. 2
FORK PREPARATION ................................................................................................................... 2
SEATPOST PREPARATION ........................................................................................................... 2
SUPPLEMENTAL DOCUMENTATION ............................................................................................. 2
WARRANTY ................................................................................................................................. 2
GEOMETRY .................................................................................................................................. 3
HARDWARE ................................................................................................................................. 4
CHAPTER 1: FORK / STEM / HANDLEBAR INSTALLATION ............................................................. 5
1. INSTALLING THE FORK INTO THE STEERER TUBE ..................................................................5
2. INSTALLING THE CARBON AERO HANDLEBAR ON THE AERO STEM .............................6
3. INSTALLING THE ALLOY HANDLEBAR WITH A STANDARD 31.8MM STEM ..................... 7
4. INSTALLING THE EXPANDER PLUG AND TOP CAP ................................................................. 7
CHAPTER 2: HANDLEBAR EXTENSION / RISER INSTALLATION .....................................................8
1. INSTALLING THE EXTENSION RISERS ......................................................................................... 8
SYSTEM WITH NO RISER SPACERS: ................................................................................................. 9
SYSTEM WITH RISER SPACERS: ........................................................................................................9
2. INSTALLING THE CLAMPS, EXTENSIONS AND ARM PADS ................................................ 10
3. ADJUSTING THE EXTENSIONS AND ARM PADS ..................................................................... 11
CHAPTER 3: CABLE HOUSING / WIRE INSTALLATION ................................................................. 12
1. INSTALLING THE BRAKE CABLE HOUSINGS AND SHIFTER WIRES ................................ 12
2. ROUTING THE DERAILLEUR CABLES / WIRES AT THE BOTTOM BRACKET ................ 14
3. Di2 WIRING LOCATIONS ................................................................................................................ 14
4. INSTALLING THE CABLE ROUTING COVER PLATE ............................................................... 15
5. INSTALLING THE CABLE ROUTING CONTROL TOWER ....................................................... 15
CHAPTER 4: BRAKE INSTALLATION ............................................................................................ 16
1. FRONT AND REAR BRAKE ASSEMBLY (Exploded view) ........................................................ 16
2. INSTALLING THE FRONT BRAKE ASSEMBLY ..........................................................................17
3. INSTALLING THE REAR BRAKE ASSEMBLY ........................................................................... 18
4. ADJUSTING THE FRONT AND REAR BRAKE ASSEMBLIES ............................................... 19
CHAPTER 5: SEATPOST INSTALLATION ..................................................................................... 20
1. INSTALLING AND ADJUSTING THE SHIV SEATPOST ............................................................20
2. SEATPOST SETBACK OPTIONS .................................................................................................. 21
CHAPTER 6: FUELSELAGE INSTALLATION ................................................................................. 22
1. INSTALLING THE FUELSELAGE .................................................................................................. 22