Desktop Quick-Start Guide • September 13, 2016
© Copyright 2016 ShopBot Tools, Inc. page 30
Switch to ShopBot FULL
Switch to ShopBot FULL in order to use additional func-
tions. To do this, click on the ShopBot EASY help (?) button.
Click on the “Switch to FULL” button.
Click “OK” on the popup window.
A command console should pop up. Note that the “EASY”
button, will easily switch back to ShopBotEASY if desired.
Surfacing the Deck
The basic Desktop deck is made out of medium-den-
sity berboard (MDF). It is a good sacricial deck, but
thickness can vary due to the manufacture of the ma-
terial and changes in humidity. The MDF deck should
be surfaced before cutting . Click on “Table Surfacer”
under “Tools” in the FULL ShopBot control. It can also
be accessed by typing “TU”.
To Next Page
Loading...