Multiple Pixel Bars (DMX Control)
1. Fasten the effect light onto firm trussing Leave at least 1 meter on all sides for air circulation.
2. Always use a safety cable (ordercode 70140 / 70141).
3. Use a 3-p XLR cable to connect the Pixel Bars and other devices.
4. Link the units as shown in (figure 4), Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
5. Supply electric power: Plug electric mains power cords into each unit's IEC socket, then plug the
other end of the mains power cord into proper electric power supply sockets, starting with the first unit.
Do not supply power before the whole system is set up and connected properly.
Design your show according to your DMX controller functions. See page 12 for more about DMX
programming.
Multiple Pixel Bars DMX Set Up
Max. 30 Pixel Bars
Fig. 4
Note : Link all cables before connecting electric power
To Next Page
Loading...
