Shure AXT400 - Networking Receivers; Automatic IP Addressing; Manual IP Addressing

Shure Incorporated
11/22
1.
2.
1.
2.
◦
◦
Icon indicates transmitter controls locked
⑫ Battery Life
Remaining runtime for the transmitter battery is displayed numerically, alternating with a segmented battery icon. Displays
battery fault codes.
Networking Receivers
The receiver uses an Ethernet connection to network with other components. For automatic network configuration, use a
DHCP enabled Ethernet switch such as the Shure AXT620 or an Ethernet router with DHCP service. Use multiple Ethernet
switches to extend the network for larger installations.
Note: For smaller systems, connect the receivers to one another using the Ethernet ports on the back panel. The devices fall back to compatible addresses if
the IP mode is set to automatic and there is no DHCP server.
Automatic IP Addressing
If using a Shure AXT620 Ethernet switch, set the DHCP switch to ON.
Set the IP mode to automatic for all devices (Util > Network > Mode > Automatic)
Manual IP Addressing
Connect the Spectrum Manager and receivers to an Ethernet switch.
Set the IP Mode to Manual for all devices:
Menu: Util > Network
Use the control wheel to set valid IP addresses for all devices. Set the subnet mask for all devices to the same val
ue.