How to fix a Shure BLX88 Microphone system when the transmitter LED is flashing red?
If the transmitter indicator LED is flashing red on your Shure Microphone system, try these steps: Replace the transmitter batteries. Change the receiver and transmitter to a different group and/or channel. Identify and shut down or remove any nearby sources of RF interference. Replace the transmitter batteries again if necessary.
Why does my Shure BLX88 Microphone system have audio dropouts?
Audio dropouts or artifacts in your Shure Microphone system can occur if the receiver ready LED is flickering or off. Make sure the receiver and transmitter are positioned within the specified system parameters. The system should be set up within the recommended range and the receiver should be kept away from metallic surfaces. For optimal sound, the transmitter must be used in line of sight from the receiver.
What to do if my Shure BLX88 has no sound?
If your Shure Microphone system produces no sound or only a faint sound, try the following: First, ensure the transmitter is turned on. Second, check that the batteries are correctly installed. Third, perform the transmitter setup. Finally, insert fresh batteries.
What to do if Shure BLX88 transmitter indicator LED is flashing red?
If the transmitter indicator LED on your Shure Microphone system is flashing red, replace the transmitter batteries.
Why is the receiver ready LED off on my Shure BLX88 Microphone system?
If the receiver ready LED is off on your Shure Microphone system, ensure the transmitter is turned on and the batteries are correctly installed. You may need to perform the transmitter setup. If not, insert fresh batteries.
What to do if Shure Microphone system has no sound?
If your Shure Microphone system produces no sound or a faint sound, verify all sound system connections and adjust the gain as needed. Also, ensure that the receiver is properly connected to the mixer or amplifier.
How to fix distortion in Shure BLX88 Microphone system?
If the audio LED on the receiver of your Shure Microphone system indicates an overload (red), reduce the transmitter gain. See Adjusting Gain.
General| Type | Dual Channel Receiver |
|---|---|
| Number of Channels | 2 |
| Power Source | External power supply |
| Number of Frequencies | Up to 12 compatible systems per frequency band (region dependent) |
| RF Output Power | 10 mW (typical) |
| Power Supply | Included |
| Compatibility | BLX Series |
| Audio Output | XLR and 1/4" output connectors |
| Power Requirements | 12-18V DC, 250 mA |
| Weight | 429 g |
| Operating Range | Up to 300 ft (100 m) |
| Receiver Type | Diversity |
| Receiver Outputs | XLR and 1/4" |
| Audio Frequency Response | 50 Hz to 15 kHz |
| Dynamic Range | 100 dB |
| Total Harmonic Distortion | < 0.5% |
| Battery Life | Up to 14 hours (with 2 AA batteries) |
| Dimensions | 40 mm H x 388 mm W x 116 mm D (1.6 in x 15.3 in x 4.6 in) |
Covers essential safety precautions for operating the BLX wireless system.
Steps for connecting receiver to power and performing a group scan.
Guide for installing batteries, setting transmitter, and adjusting gain.
Step-by-step guide for setting up a single wireless system.
Instructions for manually setting the transmitter group.
Instructions for manually setting the transmitter channel.
Guidelines for setting up multiple wireless systems simultaneously.
Procedure for manually changing the receiver's group setting.
Procedure for manually setting the receiver's channel.
How to lock and unlock the transmitter controls.
Suggestions for optimizing wireless system performance and reducing interference.
How to adjust transmitter gain using the receiver's audio LED indicator.
Information on expected battery life and how to replace batteries.
Solutions for issues related to no sound or faint sound.
Steps to resolve audio artifacts and signal dropouts.
To Next Page
