Shure Incorporated
2/103
MXWMicroflex® Wireless 4
IMPORTANT SAFETY INSTRUCTIONS 4
Overview 4
General Description 5
Features 5
MXW Wireless System 7
Hardware Description 10
Audio Network Interface (ANI) 11
Access Point Transceiver (APT) 14
Networked Charger (NCS) 16
Microphone Transmitters 18
Rechargeable Batteries 24
Installation 29
Additional Equipment 29
Connecting MXW Components 30
Rack Installation 32
Securing the Charging Station 32
Two-Channel Charger Wall Mount 33
Mount the Access Point Transceiver 38
Power the Hardware 40
Open the MXW Control Software 41
System Set Up 42
Group Devices to Form Audio Channels 42
Channel Routing between Devices 46
Link Microphones to Group Channels 48
Preparing a Backup Microphone 50
Exchanging or Removing a Component 52
Link a Microphone Over the Network 52
Large Installations 53
Shure SystemOn Software For Managing Large Systems 5
3
High Density Mode 53
Configurations: Managing Multiple Groups 53
Wireless Management 55
Overview of Channel Coordination 55
Scanning Available RF Spectrum 56
PHS Detection 57
Identifying PHS Detection Errors 58
Setting RF Power 59
Using Multiple 2- or 4-Channel Access Points 60
Networking 62
Networking Best Practices 62
Configuring IP Settings 63
Advanced Setup 65
Software 68
Shure Web Device Discovery Application 69
MXW System Control Software 70
Control Software for the MXW Audio Network Interface 82
Dante Software by Audinate 84
Firmware Updates 85
Troubleshooting 85
Additional Resources 87
Factory Reset 87
Accessories and Model Variations 88
Microflex Wireless Specifications 92
System 92
Transmitters 93
Access Point Transceiver (APT) 95
Networked Charging Station (NCS) 96
To Next Page
Loading...
Need help?
General
