Shure Incorporated
77/103
◦
◦
The device model number.
⑥ Name
Displays device name as defined in the Configuration tab or channel name as defined in the Monitor tab.
⑦ IP Address Control
Displays the IP Address of the control network interface (Shure control data).
⑧ IP Address Network Audio
Displays the IP Address of the Network Audio network interface (Dante digital audio data).
⑨ Battery Capacity
The microphone battery's percentage of charge capacity as compared to a new battery.
⑩ Cycle Count
Number of charge cycles logged by the battery.
⑪ Firmware Version
Displays the device's firmware version.
⑫ ID Button
Sends a signal to the device to flash its LEDs for easy identification.
⑬ Device Properties
Opens a window for editing the properties of an individual device. The button displays yellow when the properties have
been edited for that device. The changes can be applied or cancelled from the Pending Changes Button on the Utility tab.
⑭ Pending Changes Buttons
These buttons apply or cancel any changes made to the device properties:
Apply All: Confirms and executes all updates to device properties. At this time, the computer may lose connection to the
control software.
Cancel All: Clears all pending changes to the device properties.
Device Properties
Edit the settings for each device by opening the Device Properties window from the Utility tab. Device properties are edited in
dividually, but are uploaded to the devices in bulk by selecting the Apply All button from the Utility tab. This ensures that the
changes are deployed properly across the network.
Some settings vary depending on the device capabilities.
To Next Page
Loading...
Need help?
General
