Shure Incorporated
79/103
◦
◦
◦
◦
◦
◦
④ Reboot
The unit performs a power cycle.
⑤ Factory Reset
Resets the device to default settings, clearing any MXW Group and Link associations. The password to access the control
software will reset to admin.
⑥ Network Interface(s)
View and adjust IP settings for the device's network interface(s). Network settings are different for each device. See the
Networking section for configuring each MXW device.
Control: Shure control (software interface operation, firmware updates, Shure Device Discovery application).
Network Audio: Dante network audio (digital audio networking and Dante software).
⑦ IP Mode
Sets IP mode of the selected network interface:
Auto (DHCP): For automatic assignment of IP addresses.
Manual (Static): For Static IP addresses.
⑧ IP Settings
View and edit the IP Address, Subnet Mask, and Gateway for each network interface.
⑨ MAC Address
The network interface's unique identification.
⑩ Density Mode
Sets the density mode set on the APT:
Standard density (default)
High density (doubles the available channels)
⑪ RF Mode Settings
For APT2 and APT4 installed in adjacent rooms, alternate modes (Mode A, Mode B) to get the best RF performance.
⑫ Add Updates
Select Add Updates to save the device changes to the control software. All device properties are updated simultaneously
from the Utility tab. Once saved, the device will show Pending under the Properties column.
⑬ Cancel Updates
Remove any changes made to the device properties.
To Next Page
Loading...
Need help?
General
