Shure Microflex MXWNCS4 User Manual

Shure Incorporated
61/103
1.
2.
3.
4.
Alternate Antenna Modes to use the Full Spectrum
Requirements
The MXW system must be operating on a minimum firmware version of 2.0.0.
Set Up
Open the MXW control software using the Shure Web Device Discovery application.
Go to the Utility page.
Open the Device Properties window for the two- or four-channel access point (MXWAPT2 or MXWAPT4).
Note that the APT is set to Mode A by default (Device View > RF Mode Settings > RF Coordination Mode). Close
out of the window.

Shure Microflex MXWNCS4 Specifications

General

Brand	Shure
Model	Microflex MXWNCS4
Category	Microphone
Language	English