Shure Microflex User Manual

2
Connect the Components
②
①
②
③
④
①
7
8
6
5
1
2
3
4
7
8
6
5
1
2
3
4
7
8
6
5
1
2
3
4
③
Class 0 PoE
1. Connect MXW components
Use shielded Ethernet cables to connect MXW components together.
Use the 4-port switch on the Audio Network Interface (ANI) or connect all
components to a separate gigabit switch.
ANI Network Port To Component
① Port 1 (PoE) Access Point Transceiver (APT)
② Port 2 Networked Charging Station (NCS)
③ Port 3 (Optional) Additional NCS
④ Port 4 Computer
Note: In default settings, MXW devices are set to Automatic (DHCP)
mode to automatically configure to compatible IP settings. In the absence
of a DHCP server, the devices will use a Link Local (169.254.x.x) address
format.
2. Connect ANI analog outputs
Use shielded audio cables to connect the outputs of the ANI to a mixer,
DSP, or teleconferencing device. (Reference the Hardware kit supplied with
the ANI to properly wire the cables to the block connectors.)
Included Accessories
Component Accessory
APT
Shure USB Flash Drive (contains Shure Web Device
Discovery application, Shure Firmware Update Manager
application and user guides)
Mounting Plate
Paintable Cover
ANI
Hardware Kit (rackmount screws, cable connector
assemblies)
IEC Power Cable
NCS DC Power Adapter
Additional Equipment
Audio cables
Use shielded audio cables for connecting the ANI to a mixer, DSP, or
teleconferencing device.
Ethernet cables
Use shielded Cat5e (or higher) cables to network MXW components.
Computer
Use a PC or Mac to access the MXW System interface from a web-browser.
Equipment Inventory

Shure Microflex Specifications

General

Transducer Type	Condenser
Polar Pattern	Cardioid, Supercardioid, Omnidirectional
Frequency Response	50 Hz - 17 kHz (varies by model)
Output Impedance	150 ohms
Power Requirements	11-52 V DC Phantom Power
Connector	XLR
Weight	Varies by model
Dimensions	Varies by model