Shure Incorporated
2/50
MXA920 Ceiling Array Microphone 4
Getting Started 4
Designer Setup Example 4
Web Application Setup Example 6
MXA920 Parts 7
Power Over Ethernet (PoE) 9
Model Variations 9
Optional Accessories and Replacement Parts 9
MXA920 Codec Certifications 9
What's in the Box 9
Reset Button 10
Reset Modes 10
MXA920 Control Software 10
Control Devices with Shure Designer Software 11
Use Designer's Auto Route 11
Mute Sync 12
MXA920 Coverage 13
Add Coverage Areas 13
Prevent Unwanted Sounds 16
Use Steerable Lobes 16
Adjust Levels 16
How to Install the MXA920 17
Installing in a Ceiling Grid 18
VESA Standardized Mounting 21
Suspending from the Ceiling 21
Install on a Ceiling with the A900-CM 21
Hard Ceiling Mounting 22
Dante Channels 22
IntelliMix DSP 22
DSP Best Practices 22
Acoustic Echo Cancellation 22
Noise Reduction 23
Automatic Gain Control (AGC) 24
Delay 24
Compressor 24
Parametric Equalizer 24
Automix 27
Automix Channel 27
Automix Settings 27
Automix Modes 29
Encryption 29
Set Up the 802.1X Protocol for a Device 29
Turn Off or Clear 802.1X Settings 30
Change 802.1X Settings 30
Troubleshooting 802.1X Setup Issues 31
Networking Best Practices 31
Switch and Cable Recommendations for Dante Network
ing 31
Device IP Configuration 32
Setting Latency 32
QoS (Quality of Service) Settings 32
IP Ports and Protocols 33
Digital Audio Networking 34
Compatibility with Dante Domain Manager 34
Dante Flows for Shure Devices 34
AES67 35
Sending Audio from a Shure Device 35
To Next Page
Loading...
