Shure PGX Wireless User Manual

SHURE PGX WIRELESS
6
Single System Setup
In any wireless setup, each transmitter and receiver pair must be tuned to
the same frequency, or channel. The PGX wireless system uses automatic
transmitter setup to synchronize the transmitter and receiver channels.
Note: transmitting devices such as cellular phones and two-way radios, and
digital devices such as CD players and effects processors, may interfere with
wireless audio transmissions. Keep your PGX transmitters and receivers
away from these and other potential sources of interference.
Single System Setup
1. Automatic Frequency Selection
Press and release the channel button. This scans for a clear channel and
sets the receiver to that channel.
2. Automatic Transmitter Setup
Turn On the transmitter.
Open the transmitter battery compartment to display the infrared (IR) port
(see pages 4 and 5).
With the transmitter IR port exposed to the receiver, press sync.
Hold the sync button until the red light stops flashing on both receiver and
transmitter.
When the receiver ready light glows, the system is ready for use. Close the
transmitter battery compartment.
channel
LED screen displays
current channel
press channel button
to scan for a clear
channel
system scans for
clearest available
channel
s
y
n
c
r
e
a
d
y
a
u
d
i
o
c
h
a
n
n
e
l
s
e
l
e
c
t
< 15 cm (8 in.)
or
sync

Shure PGX Wireless Specifications

General

Brand	Shure
Model	PGX Wireless
Category	Microphone system
Language	English