Shure Incorporated
13/15
2.
3.
4.
5.
6.
7.
8.
1.
2.
3.
1.
2.
Select Add Receiver to My System.
To change the group, rotate the control knob to select G:, push to select, rotate to change the number, push again to
confirm.
Select start scan.
After the scan completes, push the control knob to apply the receiver channel.
Turn on the transmitter you plan to use with this receiver.
Align the infrared (IR) port on the transmitter with that on the receiver, and push the sync button.
Once the sync is complete, the system is ready for use.
Manual Frequency Selection
To manually adjust group, channel or frequency:
Select 1. Frequency Setup > 1.4 Manual Frequency Setup from the receiver menu.
Use the control knob to select and adjust the group (G), channel (C), or frequency (MHz).
Select apply and push the control knob to save.
Sound Check and Gain Adjustment
Navigate to the receiver's Gain screen to test the transmitter at performance levels. Adjust the gain to keep the audio indicator
within the optimal range. Reduce the gain if there is audible distortion of the audio.
More Information Available Online
A comprehensive online user guide is available at pubs.shure.com.
Certifications
Information to the user
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
theFCCRules.Theselimitsaredesignedtoprovidereasonableprotectionagainstharmfulinterferenceinaresidentialinstalla
To Next Page
Loading...
Need help?
General
