Part #1510 - Universal Bib Style Headrest Complete with foam
Part #1510A - Universal Bib Style Headrest Cover Only
Part #3412 - Replacement Backrest
Part #1436 - Kickplate Cover Replacement
Replacing Backrest
1. Remove the headrest and the padded backrest extension from the carriage.
2. You will first need to determine if your machine is made before 2017 as the backrest was attached with hex head
bolts to the carriage. If this is the case you will find two bolts at each end of the backrest on the underside of the
carriage.Remove bolts to release your backrest upholstery. If your backrest is attached!with velcro you will need to pry
the backrest loose from the carriage with a long!flat screwdriver or a flat!pry bar. Once removed, replace it with a new
backrest. The new backrest will come with the velcro pads to update your older models.
3. Insert the new backrest. It should rest at the top of the carriage; leaving room for the padded backrest extension at
the foot-end of the carriage.
4. Press down on the backrest to secure it to the carriage.
Inspect Rebound Elastic
As the carriage rolls to either end of the track, the rebound elastic provides a soft stop by resisting the two black
rebound ropes from separating. If the rebound elastic becomes damaged, it can easily be replaced by unclipping the
two mini carabiners from the black rebound ropes. It is important to note the placement of the rebound elastic is on
the black ropes between the attach point on the carriage and the first eye bolts.
To Next Page
Loading...
