What to do if Sibata LD-5 measurement value is abnormal (high)?
If you observe a high, abnormal measurement value on your Sibata Measuring Instruments, the sensitivity correction might be off. Try closing the air sampling port and performing the SPAN measurement several times after you've done the BG measurement. This may resolve the issue.
Why Sibata LD-5 shows nothing after switching the power ON?
If your Sibata Measuring Instruments shows no display after powering on, it could be due to a couple of reasons. First, the AC adapter might not be properly connected, so check that connection. Second, the battery level might be too low, so consider replacing the batteries.
What to do if Sibata LD-5 Measuring Instruments measurement value is abnormal (low) or there is no count?
If you're getting an abnormally low measurement value or no count on your Sibata Measuring Instruments, several factors could be at play. Here are a few things to check: * Ensure the air sampling port cap is open before measuring. * If the BG measurement value or sensitivity correction is abnormal, perform the SPAN measurement after the BG measurement. * Check if the pump filter is clogged. If so, replace it and reset the operating time. * Clean the air sampling port with a brush. If these steps don't resolve the issue, the laser may be malfunctioning or the suction pump may have failed, requiring repairs or calibration.
Why Sibata LD-5 Measuring Instruments bar graph display is unstable even when measurements are not performed?
If the bar graph display on your Sibata Measuring Instruments is unstable even when you're not taking measurements, it's possible that dust inside the detector is being misinterpreted as a measurement value. Try closing the air sampling port and performing the BG measurement several times. If this doesn't fix the issue, the unit might need an overhaul.
What to do if Sibata LD-5 LCD is OFF?
If the LCD on your Sibata Measuring Instruments is off, it's likely that the LCD sleep function has been activated. Simply press any switch to restore the display.
Why Sibata Measuring Instruments measurement value does not change?
If the measurement value on your Sibata Measuring Instruments isn't changing, the scattering plate might be inserted. Make sure to turn the scattering plate knob to the [MEASURE] position and that the air sampling port is open.
What to do if Sibata Measuring Instruments LCD screen does not change or the content displayed is strange?
If the LCD screen on your Sibata Measuring Instruments isn't changing or the display is strange, it might be a temporary LCD issue. You can try the following: 1. Press the [ESCAPE] switch. 2. Press the [UP] or [DOWN] switch. 3. Press the [ENTER] switch. After doing one of these, switch to your desired mode. You can also try pressing and holding the [ESCAPE] switch for at least two seconds to turn the LCD off, then press any switch again to restore the display. Alternatively, turn the power switch off and then back on. If none of these steps work, the unit may need repairs.
How to fix the issue when Sibata LD-5 current time has been reset?
If the current time on your Sibata Measuring Instruments keeps resetting, the backup battery is probably depleted. Replace the backup lithium battery to resolve this.
What to do if Sibata LD-5 data cannot be recorded?
If your Sibata Measuring Instruments is unable to record data, it's likely that the memory is full. To fix this, go to the log setting mode and delete some of the existing data.
General| Brand | Sibata |
|---|---|
| Model | LD-5 |
| Category | Measuring Instruments |
| Language | English |
To Next Page
